RX8--Transmission (Manual & Auto)

FLYWHEEL AND DRIVE PLATE DRIVE PLATE REMOVAL/INSTALLATION Remove the transmission (See AUTOMATIC TRANSMISSION REMOVAL/INSTALLAT ...

Drive Plate Removal Note Set the SST against the engine. Remove the bolts and the drive plate. Drive Plate Installation Note ...

{4.26.3 kgf·m, 30.445.5 ft·lbf} Install the transmission. (See AUTOMATIC TRANSMISSION REMOVAL/INSTALLATION .) (w) RX-8 Trans ...

OIL COOLER OIL COOLER FLUSHING NOTE: The contaminated cooler line (oil pipes and hoses) and auxiliary cooler must be flushed co ...

Power Flushing Repair procedure Before power flushing, inspect the hoses/lines and clamps. Power flushing must begin with back ...

Flush oil cooler/lines until discharged fluid is clean. OIL COOLER REMOVAL/INSTALLATION Remove the engine cover. (See ENGINE ...

1 Connector bolt 2 Washer 3 Oil hose (See Oil Pipe, Hose clamp, Oil hose Installation Note .) 4 Hose clamp (See Oil Pipe, Hose c ...

Radiator (In Tank Oil Cooler) Installation Note The automatic transmission oil cooler flushing must be performed whenever a tra ...

OIL COOLER DISASSEMBLY/ASSEMBLY Disassemble in the order indicated in the table. Assemble in the reverse order of disassembly. ...

Insert the end of a medium tip screwdriver between the end of the header tab and the outer tank. NOTE: Do not open more tabs ...

Radiator Outer Tank (In Tank Oil Cooler) Assembly Note Install a new O-ring and ensure it is not twisted. NOTE: The old O-rin ...

Verify that the height of the header tabs is same as the height before removal. Inspect for leakage from radiator. (See ENGINE ...

AUTOMATIC TRANSMISSION CONTROL SYSTEM WIRING DIAGRAM (w) RX-8 Transmission (Manual & Auto) ...

AUTOMATIC TRANSMISSION INPUT (SENSOR/SWITCH) TRANSMISSION RANGE (TR) SWITCH INSPECTION Operating inspection Verify that the sta ...

Disconnect the TR switch connector. Verify continuity as indicated in the table. If there is any malfunction, adjust the TR swi ...

Install the insulator. Tightening torque o 8 11 N·m {82112 kgf·cm, 7297 in·lbf} Install the catalytic converter. (See EXH ...

Separate the manual shaft lever component from selector lever. Disconnect the TR switch connector. Rotate the manual shaft to t ...

Remove the TR switch. Rotate the manual shaft to the extension housing side fully and return two notches to set the N position. ...

Inspect for continuity between TR switch terminals C and D. Remove the SST. Install the manual shaft lever component and washer ...

Install the manual shaft lever component installation nut. Tightening torque o 10.814.7 N·m {1.11.4 kgf·m, 8.010.8 ft·lbf} ...