Mechanical APDL Basic Analysis Guide

set,2,1

/title, Pressure distribution; time=30, temp=150

eplot

finish

The following plots illustrat e the pressure distribution for the two load cases.

Figure 2.19: Pressure Distribution for Load Case 1

Figure 2.20: Pressue Distribution for Load Case 2

Note the difference in the pressure load in the second load case.

2.5.16. Applying Loads Using Components and Assemblies

You can use components and assemblies to apply loads to portions of the model.

Applying a Load to a Component

Apply loads to portions of the model using a component as follows:

CM,cmp,Entity

SF,cmp,CONV,10

The SF command specifies the film coefficient of 10 on nodes in the component (cmp). All nodes in
the component are retrieved regardless of the entity type.

Release 15.0 - © SAS IP, Inc. All rights reserved. - Contains proprietary and confidential information

Loading