Introduction to SolidWorks

(Sean Pound) #1

Lesson 10 – Creating Assemblies and Sub-Assemblies
Section IV – Modeling Assemblies 10.4 The Tire and Wheel Sub-Assembly


 Next, select the flat surface of one of the wheel bumps and the equivalent cavity in the
tire and make them Coincident. In the Heads-Up View toolbar, click on the Wireframe
view to see the interior details and to verify that the orientation of the two parts match.
See Figure 10.5. Click on the Shaded With Edges icon to return. You can also
experiment with the Section command in the Heads-Up View toolbar or right-click on
the part and select the Change Transparency icon.
 Finally, make the face of the wheel and the side face of the tire Coincident.
 Save the model as TireAssembly.sldasm.

Figure 10. 4 – Selecting Concentric Mate
Free download pdf