Introduction to SolidWorks

Lesson 12 – Creating Detail Drawings
Section V – Creating Engineering Drawings 12.3 Creating a Drawing Template

 In ToolsOptions select the System Options tab, click FeatureManager and verify

that the Design Binder pull-down menu says Show.

 Your screen should look like Figure 12.4.

Step 100: Click on ToolsOptionsDocument Properties and verify the following choices:

 Drafting Standard – Verify that ANSI is selected. See Figure 12.5.

 Units – Select IPS (inches, pounds, seconds).

Figure 12. 4 – ToolsOptionsSystem Options