Introduction to SolidWorks

Lesson 3 – Modeling the Skateboard Deck Using Extruded Boss/Base
Section II – Modeling Simple Parts 3.3 The Skateboard Deck

holes must be drilled through the thickness. Verify that your menu choices match the

figure and click the Position tab to locate the holes.

 Next, SolidWorks asks for the location of the hole(s). Click to mark the approximate

location of two parallel holes as shown in Figure 3.9. Only the approximate location is

required. Like any SolidWorks sketch, we will define the exact locations and

relationships after we create the geometry.

 Click the check mark.

Figure 3. 8 – Hole Wizard Dialog Box