Introduction to SolidWorks

(Sean Pound) #1

Lesson 5 – Modeling Miscellaneous Rubber Parts
Section II – Modeling Simple Parts 5.4 Modeling the Truck Bumper


 Select the Draft On/Off option and type 5 degrees draft.
 Click the check mark to accept.
 Use Section View in the View Heads-Up toolbar to verify that the diameter is smaller at
the end of the extrusion.

Step 31: Create a dome cavity on the surface created by the Extruded Cut.


 Click the surface.
 Click the Dome command.
 Type 0.21 inch in the distance input box.
 Click the Reverse Direction arrows to toggle the dome and to create a cavity instead of
a solid dome. See Figure 5.5.
 Click the check mark to accept.

Figure 5. 4 – InsertCutExtrude
Free download pdf