Introduction to SolidWorks

(Sean Pound) #1

Lesson 6 – Editing Parts
Section II – Modeling Simple Parts 6.3 Adding Bumps to the Wheel


 Notice that Inference changes the color of the
circumference to red to indicate that the lower
left corner of the rectangle is coincident with the
edge of the wheel.
 If you cannot sketch a rectangle with the corner
in the desired location, try Zoom. Sometimes
lines, circles and other geometric entities cannot
be made active because they are too small.
 If Zoom does not work, use Add Relation to
make the corner coincident with the edge.

Step 37: Add the dimensions in Figure 6.1 to fully define
the sketch.


Step 38: Extrude using Midplane and extrude length of
1.0 inch as shown in Figure 6.2. Notice that the bumps
do not extend to the edges of the wheel.


 Select the Mid Plane option.

Figure 6. 2 – Wheel Bump Extrusion (^)
Figure 6. 1 – Sketch for the Wheel Bump

Free download pdf