Introduction to SolidWorks

Lesson 6 – Editing Parts
Section II – Modeling Simple Parts Practice Exercises

SIDEBARS

Practice Exercises

1. Explain the difference between Edit Sketch and Edit Feature.


2. Edit the Tire Part model to include the pockets that match the bumps in the wheel.


3. Re-draw the parts modeled in this Lesson using millimeters instead of inches. Use a
   mmPart template and use the dimensions in the detail drawing in the Appendix.

Questions

1. What is the hardness of ABS plastic?


2. What kind of rubber you would recommend for the tire?

References

Inside SolidWorks – 4 th Edition, by David Murray, Thomson Delmar Learning (2005).

SolidWorks Office Training Manual – Essentials, by SolidWorks Corporation.

Internet Resources

http://www.exploratorium.edu/skateboarding/

http://skateboard.about.com/