Lesson 8 – Modeling the Truck Base
Section III – Modeling Complex Parts 8.3 Modeling the Truck Base
Step 65: Select the surface of the pocket and sketch a circle 3/8 inch in diameter and Extruded
Cut using Through All. See Figure 8.7.
Step 66: Select the surface of the pocket
again and sketch the square shown in
Figure 8.8. The sides of the square are 0.75
inch and it is centered on the origin.
Use the Center Rectangle option.
Step 67: Click on the Extruded Cut icon in
the Features toolbar and select the options
in the dialog box on Figure 8.9.
Notice that the pocket starts at an
offset of 0.32 inch from the sketch
surface and ends at Up To Next.
Figure 8. 7 – Hole for Bolt
Figure 8. 8 – Rectangle Sketch for Bottom Pocket