V t D
B t D v
By Sephi Kemp
METHOD
1 Lay a few pieces of silver mesh on thick cardboard
135mm square then cover them with adhesive foil
tape in a haphazard patchwork design.
2 Make indentations in a few areas using an eyelet
setting tool. Dab VersaMark ink in a few places,
then emboss them with verdigris powder.
3 Lightly brush black paint over the whole panel
then wipe it back with a cloth, leaving paint
around the edges and in all the grooves.
4 Layer it on cream card 140mm square and folded
red card 150mm x 300mm on an angle as shown.
5 Attach a Darkroom Door photobooth hats image
on thick cardboard 65mm x 55mm, set two
bronze eyelets on either side at the bottom, then
thread wire through them in a crossover pattern
and add it to the centre of the card.
6 Cut 10 assorted banners out of patterned paper,
glue them along the top of the card, add alphabet
letters to spell ‘Dad’, then glue on holographic
stars and red rhinestones.
7 Add two bows of ribbons and a small key charm at
the bottom.By Michelle Corlett
METHOD
1 Layer My Mind’s Eye Hattie teal dot paper
145mm x 100mm on folded white card
150mm x 210mm.
2 Affi x grid paper 40mm x 95mm on Fancy Pants^
kraft corrugated card 140mm x 95mm, then add
vellum 90mm x 80mm, a 3in white circle and
Hattie chequered paper 75mm x 55mm as shown.
3 Tie twine around the left-hand side of this panel
twice and secure it to the card. Tie two Stampin’
Up! buttons with twine and add them too.
4 Stamp Avery Elle The Man sentiment and beer
bottle outlines on white card with Memento
tuxedo black. Stamp the beer with StazOn
saddle brown ink.
5 Cut the sentiment to 35mm x 45mm^ then
fussy-cut the bottles and secure them all
as shown.
6 Add Stampin’ Up! dazzling diamonds to the
bubbly area on the bottles to fi nish.