Truckin Tech Avoiding the Shaft
- TRUCKIN.COM [7 4 ] OCTOBER 2019 -
19. Then the weight is chiseled off the old-fashioned way.
20. Now Carlos uses a piece of emery cloth to sand the
entire shaft and reveal a nice clean surface.
A couple of different size weights were temporarily
wire-tied to the shaft before it was given another spin.
Once we achieved the IEDLS standard of 0 to .001, the
weights were welded in place.
Carlos gave the welded areas a quick cleanup with the wire brush.
At this point, we gave the shaft one more pass with the emery cloth,
followed by Scotch-Brite.