Figure 2
Wiring connections at controller
- Cut the wire ties and remove the clamp securing the wiring harness and FSR cable in the cab.
Figure 3
Wiring and FSR cable ties in cab
1.
2.
3.
Cable & harness clamp
Wiring harness connectors
Cable tie straps
- Place the operator platform in the tilt position. Refer to810 Operator's platform, raising.
- Remove the clamps and cable ties securing the FSR cable on the underside of the operators platform and also
remove any clamps or ties following the cable routing around the frame to the hydrostatic pump.
