GUIDE ROLLER ASSEMBLY:
- Guide rollers SCCGR-25 4 No
- Bearings SMF 106ZZ 8 No
- Sleeve Guide roller SCCSL06 8 No
- M3 washers 2 fitted between bearings 8 No
(to hold sleeves apart so no end load is carried on
bearings due to retaining screw ) - Stand off (18mm long) SCCGRSO 4 No
- Large top washer 12mm Dia.STAND OFF WASHERS 4 No
- M3 or 1/8” Whitworth screw with nuts and washers 4 No
to secure assy to chassis. Length to suit your chassis
thickness to be provided by you.
OTHER COMPONENTS:
- Solar Panel SOLAREX SX-10 1 No
plus plastic edging as reqd
( NEED TO STRIP ALUMINIUM EDGING
OFF PANEL TO REDUCE WERIGHT) - Velcro for panel attachment to body self adhesive 700 mm
- Corflute for body 450 by 600 2 No
- Double sided tape and duct tape as required
- Switch ( plus wire as required) 1 No
- Electronics ENGELEC Max 4 1 No
- Faulhaber 2232 or 2224 6 Volt motor 1 No
- Plastic chassis PVC ,110mm by 490mm by 3.0 mm 1 No
- Saddles axle mounting 6mm cable clips 8 No
- Screws M2 by 12mm long + nuts and washers 8 No
- Other components as required
PERFORMANCE OF THIS CAR:
In order to enable you to evaluate this design the parameters for use in the Mathematical
Simulation for this car are entered into the simulator detailed later in this document.
NOTE: the details entered in the simulator refer to a car with some modifications to
improve performance. Also the air drag coefficient listed is for this car which has a
frontal area of 15800 square mm and a very poor aerodynamic shape. You can ratio this
drag figure based on areas to obtain a representative figure for your car. It would be
difficult to build a car with worse aerodynamics so you will be looking at somewhere
near worst case aerodynamic drag coefficient by using this method.