Precisely hovering the mouse cursor over the end of a clip changes it between trimming the
Out point (open to the left) and trimming the In point of the next clip (open to the right). In
this case, there’s no next clip, of course.
Note
If you make a clip shorter, it will leave a gap between it and any adjacent clips. Later
in this lesson you’ll learn to use the Ripple Edit tool to automatically remove any
gaps or push clips later in a sequence when you trim a clip longer.This clip has a transition effect applied to the end. You may need to zoom in to make it
easier to trim the clip and not retime the transition effect.
5. Drag the edge to the right until it meets the end of the audio file.A tooltip shows you how much you’ve trimmed.6. Release the mouse button to apply the trim.Performing advanced trimming
The trimming methods you’ve learned so far have their limitations. They can leave unwanted
gaps in the sequence caused by shortening a clip. They can also prevent you from lengthening
a shot if there’s an adjacent clip.
Fortunately, Premiere Pro offers several more ways of trimming.
Note
When performing a ripple edit, you might shift items on other tracks out of sync. By
default, sync locks keep items on all tracks in sync.Tip
The keyboard shortcut for the Ripple Edit tool is B.Making ripple edits
You can avoid introducing gaps when trimming by using the Ripple Edit tool rather than
the Selection tool.
You use the Ripple Edit tool to trim a clip in the same way you use the Selection tool. When you
use the Ripple Edit tool to change the duration of a clip, the adjustment ripples through the
sequence. That is, clips after the clip you adjust slide to the left to fill the gap, or they slide to the
right to make room for the longer clip.
Let’s try it.
1. Open the sequence 11 Ripple Edit.