Step 6
We need to drill a hole through the end of the long boards and through
the handle. Figure 3 shows the placement of the hole in the long boards
and the handle. Drill the hole for the handle separate from the holes
through the long boards. Because the bottom of the handle is notched to
help catch the catapult arm there’s not much room for error in drilling
this hole, so pay careful attention to place the drill bit in the center of the
wood.
½”
¾”
Long board
5/8”
¼”
Handle
Now we can assemble the handle and the catapult arm. Just as we did
before, slide a washer over the bolt, insert the bolt then place another
washer on the end of the bolt, and finally the lock nut. The catapult arm
uses a 4 ½” bolt and the handle uses the 3” bolt. The catapult arm needs
to be able to move freely so just tighten the lock nut enough so that the
bolt doesn’t move.
Fig. 3