untitled

6. Insert wires to connect the IC, voltage regulator, transmitter, and ter-
   minal blocks, as shown in Figure 13-12.

The next step is to drill all kinds of holes into which you can pop various

components to create the remote control box. Follow these steps to do so:

1. Drill holes in the box where you will mount the on/off switch, speed
   switch, horn switch, start/stop switch, transmit switch, and antenna,
   as shown in Figures 13-13 and 13-14.
   You can rearrange the switches. Just be careful not to put a switch
   where it will be in the way of the battery pack when you mount it inside
   the box.

Battery TB to VR1 input pin Pin 17 of IC1 to transmitter data input pin

S1 TB to Pin 10 of IC 1

S4 TB to Pin 14 of IC 1 S2 TB to Pin 12 of IC 1

S3 TB to Pin 13 of IC 1

Figure 13-12:
Hook up the
ICs, terminal
blocks
(TBs),
transmitter,
and voltage
regulator.

Chapter 13: Sensitive Sam Walks the Line 317