untitled

7. Insert the following, as shown in Figure 13-27:
   
   
   • Six 0.1 microfarad ceramic capacitors (C1, C3, C6, C7, C9, C11)
   
   
   • Six 10 microfarad electrolytic capacitors (C2, C4, C5, C8, C10, C12)
   
   
   • 51 kohm resistor (R1)
   
   
   • Three 10 kohm resistors (R3, R5, R7)
   
   
   • Two 150 ohm resistors (R4, R6)
   
   
   • 330 ohm resistor (R2)
     Use both the schematic and the photo to help you place each compo-
     nent. For example, the schematic shows that the + side of C5 is con-
     nected to Pin 2 of IC2 and the other side of C2 is connected to ground, so
     insert the long lead of C2 in the same row as Pin 2 of IC2 and the short
     lead in the ground bus.
   
   
   
   

Pin 1

Pin 2 Pin 3

Pin 4 Pin 5

Pin 6 Pin 7

Pin 8

Figure 13-26:

Receiver

module

pinout.

330 Part IV: Good Vibrations