- R1 from Pin 15 of IC1 to Pin 16 of IC1
- R2 from Pin 6 of IC2 to Pin 7 of IC2
- R3 from Pin 7 of IC2 to +V
- R4 from right sensor TB to ground
- R6 from left sensor TB to ground
- R5 from right sensor TB to +V
- R7 from left sensor TB to +V
- C11 from +V bus to ground bus
- C12 from +V bus to ground bus
Building Sensitive Sam’s chassis ......................................................
If you’re a sensitive guy like Sam, how your body looks is very important to
you. Here are the steps to build Sam a serviceable little chassis to hold the
receiver circuit:- Solder 12" stranded wires to the motor lugs, as shown in Figure 13-28.
Figure 13-28:
Wires
soldered
to the
motor lugs.332 Part IV: Good Vibrations