TOYOTA PREVIA 91-97 REPAIR MANUAL

CHASSIS ELECTRICAL 6-35

3. Release the bulb retaining spring and remove the bulb.


4. Install a new bulb and retaining spring. Align the cutouts of the bulb
   with the protrusions of the mounting hole. Make sure the triangle faces
   upwards.


5. Connect the cords and install the cover by turning it clockwise.


6. Make sure the cover fits snugly on the mounting body. On the left
   side, install the air inlet duct.

Third Brake Light

REMOVAL & INSTALLATION

I See Figures 103 and 104

1. Open the trunk to access the third brake light.


2. Push the pin inside the clip using a punch.


3. Pull off the cover and remove the second rear cover, the second
   cover has the socket assembly integrated.


4. Carefully twist and remove the bulb if necessary.


5. Insert a new bulb.


6. Attach the socket assembly to the body, then install the outer cover.

License Plate Light

REMOVAL & INSTALLATION

I See Figures 105,106 and 107

1. Unscrew the lens from the tailgate.


2. The lens should pop off the housing quite easily.


3. Pull the bulb from the socket to replace.


4. Installation is the reverse of removal.

Reverse Lights

REMOVAL & INSTALLATION

» See Figure 108

To replace the reverse light bulbs, the rear tail gate trim panel will have

to be removed. Reach through the hole in the body panel and detach the

socket for the lamp. Replace the bulb and install the socket and trim panel.

Fig. 103 Using a punch, push in the pin to release the clip Fig.^105 Remove the lens retaining screws

t

Fig. 104 Pull off the second cover to access the bulb of the third

brake light

Fig. 106 The lens is easily separated from the housing of the

lamp