TOYOTA PREVIA 91-97 REPAIR MANUAL

8-22 SUSPENSION AND EERING

3. Loosen the trim pad retaining screws from the back side df the steer-
   ing wheel. Remove the pad by lifting it toward the top of the whi


4. Lift the trim pad and horn button assembly from the whee


5. Remove the steering wheel hub retaining nut.


6. Scribe matchmarks on the hub and shaft to aid in correct!|installa-
   tion.


7. Use a suitable puller to remove the steering wheel.


8. Installation is the reverse of removal. Tighten the wheel retaining nut
   to 26 ft. Ibs. (35 Nm).

1992-94 Models

See Figures 58 thru 71

** CAUTION

To avoid possible unexpected deployment of the air ba (if
equipped), work must not be started after approximate y 90 sec-
onds or longer from the time the ignition switch is turn d OFF
and the negative battery cable disconnected.

1. Disconnect the negative battery cable. Wait 90 seconds o
   cable is removed before proceeding.

ce the

Fig. 58 Remove the side trim panel near the combination

Fig. 59 Use a special type of screw head to remove the bolts on

the steering wheel pad

Torx Screw

Screw Case

Fig. 60 Torx head screws are used

Fig. 61 Carefully pull the wheel pad out facing away from your

face

Fig. 62 The clips retaining the wiring harness are delicate and

should be handled carefully