TOYOTA PREVIA 91-97 REPAIR MANUAL

9-40 BRAKES

No continuity

Fig. 146 Using an ohmmeter, check for continuity between each

terminal and body, if present, replace the sensor

REMOVAL & INSTALLATION

Front

I See Figures 147,148,149,150 and 151

Unbolt the speed sensor from the steering knuckle. Place a new
sensor into position and check that there is no clearance between the
sensor and the steering knuckle. Secure the sensor bolt to 69 ft I s i
Nm).

Rear

I See Figures 152,153,154,155 and 156

Unbolt and remove the sensor from the rear axle.

1. When replacing a new sensor, using sandpaper or an equival nt,
   remove the paint of the sensor installation portion. On used sensors! sim-
   ply clean the sensor with a paper towel.


2. Insert the sensor, tighten the lockbolt to 69 ft. Ibs. (8 Nm).
   Check that there is no clearance between the sensor and the rear g|de
   housing.

Fig. 147 View of the front speed sensors on 2WD and 4WD

models

Fig. 148 The speed sensor is bolted into the knuckle

Fig. 149 Remove the one bolt and lift the speed sensor out of

the knuckle

Fig. 150 Unbolt and remove the front speed sensor from the

steering knuckle