10-2 BODY AND TRIM
EXTERIOR
REMOVAL & INSTALLATION
Front
I See Figure 1
** WARNING
The doors are heavier than they appear. Support the
the bottom and use a helper during removal and instal
not allow the door to sag while partially attached and
subject the door to impact or twisting motions.
- Turn the ignition key to the OFF position. Disconnect the negative
battery cable. Wait at least 90 seconds from the time the negative battery
was disconnected to start work.
** CAUTION
Some models covered by this manual may be equipped with
a Supplemental Restraint System (SRS), which uses an air
bag. Whenever working near any of the SRS components, such
as the impact sensors, the air bag module, steering column
and instrument panel, disable the SRS, as described in Sec-
tion 6.
- If equipped with power door locks, windows or any other power
option located on the door, remove the inner door panel and disconnect the
electrical component.
Door Outer Weatherstrip
Door Glass Run
Window Regulator
Rear View Mirror
Cover
Lock Striker —ftf a.
Inside Handle Connecting Link
Door Lock Contro
Link
Door No.3 Weatherstrip
Front Lower Frame
Inside Locking No- 1 Liffk
Link Protector Service Hole Cover No.1
Hole Cover
Service Hole Cover No.2
w/ Power Window
f
Door No.2 Weatherstrip
Lock Cylinder
Retainer --- (J
Regulator Handle
Cap Door frim Lower Cover Door Speaker
Fig. 1 Exploded view of the common front door and related components