TOYOTA PREVIA 91-97 REPAIR MANUAL

10-20 BODY AND TRIM

Fig. 63 Pull the clip from the body trim panel

5. Remove the service hole cover. Using a clip remover, extract the five
   screw grommets, then remove the no. 1 and No. 2 hole covers.


6. Disconnect the two links from the door lock.


7. Using a clip removal tool, extract the clips.


8. Remove the two links then the silencer. Turn the clamp, then pull out
   the door control link and inside locking link.


9. Remove the three screws and the locking link protector.
   10 Disconnect the two links from the outside handle and the lock cylin-
   der.
   11
   12

Fig. 64 Pull the trim panel away from the body

On models with power locks, disconnect the wiring.

Remove the lock attaching screws, then the out the lock through the

service hole.

13. When installing, secure all components and use new sealant on the
    service hole covers.


14. Install the door panels and trim.

Tailgate Lock

REMOVAL & INSTALLATION

t See Figures 65 thru 70

1. Remove the tailgate trim panel.


2. Remove the three screws attaching the locking mechanism to the
   door housing.


3. Disconnect the linkage from the door lock.


4. On power locks, disconnect the harness form the solenoid.


5. Detach the cable from the latch, then extract the assembly from the
   vehicle.


6. Attach the cable to the latch.


7. Secure the wiring (if equipped) and linkage to the assembly.


8. Position the assembly into the body of the vehicle and secure with
   the retaining screws.


9. Install the secure the tailgate trim panel.

Door Glass and Regulator

REMOVAL & INSTALLATION

I See Figure 71

1. Disconnect the negative battery cable. Wait at least 90 seconds on
   models with an airbag.


2. Position the trim panel and attach it to the door. Be careful no|t| to
   damage any of the clips.


3. Secure the panel by installing the screw-type clips.

Door Locks

REMOVAL & INSTALLATION

** CAUTION

To avoid possible unexpected deployment of the air bag (if

equipped), work must not be started after approximately 90 sec-

onds or longer from the time the ignition switch is turned OFF

and the negative battery cable disconnected.

1. Disconnect the negative battery cable. Wait 90 seconds once
   cable is removed before proceeding.


2. Remove the door trim panels.


3. Disconnect the inside handle connecting linkage.


4. Disconnect the locking No. 1 link.

Ihe

Fig. 65 Common view of the rear tailgate inside components