Rear suspension - Rear shaft assembly
- Remove left side rear shaft gum cover assembly.
(a) Inscribe 2 matching marks at the dent part of gum cover
and axle beam.
(b) Bend two parts of bush frame with chisel and hammer.
Hint: bend bush frame until it reaches the hook of spe-
cial tool.
(c) Remove gum cover from axle beam with special tool.
Hint: if axle beam is damaged, please spray paint.
- Remove right side rear shaft gum cover assembly.
Hint: the removal procedures of right side are the
same as that of left side.
- Remove left side rear shaft gum cover assembly.
(a) Align the dent on new bush with the matching mark
previously making on axle beam, and then temporarily
encase gum cover into axle beam.
(b) Encase gum cover into axle beam with special tool.
Notes:
z The hook of special tool should be deeply and
actually inserted into gum cover.
z Do not damage the rubber port of gum cover.
O Do not deform gum cover frame.
- Install right side rear shaft gum cover assembly.
Hint: the installation procedures of right side are the
same as that of left side.
- Temporarily lock up rear shaft assembly
[64000120].
(a) Support rear shaft with a jack.
(b) Install rear shaft, 2 bolts and gasket, and then tempo-
rarily lock up 2 nuts.
Installation remark
Dent
Dent
Special
tool
Bending part
Rubber Special tool
port
107
