目录.p65

Brake--Vacuum booster assembly

Vacuum booster assembly.................................

Inspection on automobile...............................

1. Check the vacuum booster
   (a) Check the gas sealed performance.
   (1) Start the engine, and extinguish after one or two minutes,
   then step and release brake pedal slowly several times.
   Hint: if the first step is lowest, second and third step
   rise gradually, and this shows the gas sealed per-
   formance of booster is normal.
   (2) Step down brake pedal when engine is running, then
   extinguish the engine.
   Hint: if the distance from pedal to floor does not
   change in 30 seconds, this shows gas seal perfor-
   mance of booster is normal.
   (b) Working inspection.
   (1) When engine is at parking state, step brake pedal sev-
   eral times to check brake pedal.
   The height from floor should not change.
   (2) Step down brake pedal, then start the engine.
   Hint: if pedal drops a little, this shows working is
   normal.


2. Check vacuum check valve
   (a) Check vacuum check valve.
   (1) Remove pipe clamp, and disassemble vacuum pipe.
   (2) Disassemble vacuum check valve.
   (3) Blow air to check: in the direction from booster to engine,
   the check valve should ventilate, but its opposite direc-
   tion should not ventilate.
   (4) If finding any malfunction, change vacuum check valve.

Change..........................................................

1. Discharge brake liquid
   Note: do not spill the brake liquid on paint surface of automobile body, if having, wash it cleanly.


2. Disassemble air filter assembly [64000033]


3. Disassemble carbon canister assembly [4G18-1129020]


4. Disassemble brake main pump subassembly

Good Bad

First

Second

Third

Con-

duction

Not con-

duction

138