目录.p65

Brake--Speed sensor of rear wheels

Speed sensor of rear wheels...........................

Change..........................................................

Hint: the process for changing right side is same as the

left side.

1. Disassemble rear wheels.


2. Disassemble wiring harness of speed sensor of rear

wheel.

Disassemble the joint of speed sensor of rear wheel.

3. Disassemble left rear disk brake branch pump

assembly.

4. Disassemble rear brake disk.


5. Disassemble left rear shaft hub and bearing assem-
   bly (referring to page 129).


6. Disassemble speed sensor of rear wheel.
   (a) Fix rear shaft hub on pliers with soft gasket.
   Note: when changing shaft hub assembly, it is neces-
   sary to shake intensively to make it break off.
   (b) Use punch pin and hammer to knock out two pins.
   (c) Use special tool and two bolts (M12*1.5) to disassemble
   speed sensor of rear wheel from rear shaft hub.

Note:

z If sensor stator is damaged, change the shaft hub

assembly.

z Do not scratch the surface of shaft hub and speed

sensor.

7. Assemble speed sensor of rear wheels.
   (a) Wash contacting surface of rear shaft hub and new speed
   sensor of rear wheels.
   (b) When sensor is assembled in shaft hub, it is necessary
   to assemble sensor joint facing lower position of
   automobile.

Special

tool

Special tool

Bolt

Bolt

152