目录.p65

Engine cover/automobile door--Torsion spring of trunk cover

Torsion spring of trunk cover.............................

Change..........................................................

Hint:

z When assembling, please work by the sequence which is opposite with disassembling

sequence; if necessary, it will have assembling instruction.

z Changing procedure for right side is same as the left side.

z For torsion spring is disassembled, trunk cover does not have any tension, at this time, when

opening and closing trunk cover, it is necessary to support it with hand to prevent trunk cover

from closing for other resistances.

z Torsion spring I of trunk cover locates the upper end, and Torsion spring II of trunk cover

locates the lower end, so it is necessary to work from left side to right side when assembling;

but it is necessary to work by opposite sequence when disassembling.

1. Disassemble torsion spring of trunk cover

[68000100]

(a) Disassemble torsion spring I from middle bracket.

(b) Assemble special tool at the side of hinge.

(c) Push the special tool downwards, then pull trunk cover hinge

upwards from torsion spring I.

(d) Raise the special tool slowly, then use the special tool to

disassemble torsion spring I from the bracket.

(e) Disassemble torsion spring I from the bracket.

(f) Implement the work at the other side with same method.

2. Assemble torsion spring I of trunk cover [68000100]
   (a) When assembling torsion spring I, it is necessary to as-
   semble it on fixing clamp stably.

 378 

special tool