目录.p65

Lubrication

Lubricating system

On-vehicle inspection......................................

1. Check oil level.
   During engine warming up and after it flames out for 5 minutes, check oil level, and the level should
   be between two marks on oil dipstick at the moment.If oil level is too low, check there is leakage, and
   refill oil up to upper mark on oil dipstick.
   Note: oil level should not be above upper mark on oil
   dipstick.


2. Check oil quality.
   (a) Check there is deterioration, water penetration, color
   change or thinning with oil.
   (b) If oil quality becomes poor, please replace with new oil.
   Hint: oil grades: API, SH, SJ, SG grade oil or ILSAC
   multigrade oil. Recommended viscosity is
   shown as below.
   The temperature increases from left to right.


3. Remove oil pressure alerter assembly.
   (a) Uncouple oil pressure alerter joint.
   (b) Install oil pressure alerter with special tool.


4. Install oil pressure gauge.
   Install oil pressure gauge.


5. Warm up vehicle.


6. Check oil pressure.
   Oil pressure:


7. Install oil pressure alerter.
   (a) Coat adhesive on 2nd or 3rd circle thread of oil pressure
   alerter.
   Adhesive: anaerobic pipe thread sealing adhesive
   1545 (Kesaixin 1545).
   (b) Install oil pressure alerter with special tool.
   Torque: m
   (c) Connect oil pressure alerter joint.


8. Start engine and check there is leakage.

Lubrication - lubricating system

Recommended viscosity (SAE)

Oil pressure alerter

Oil pressure gauge

Adhesive

74

Temperature range in forecasting next

oil replacement