Simulink Control Design™ - MathWorks

No permanent openings. Use the addOpening command to add new permanent openings.

Properties with dot notation get/set access:

Parameters : []

OperatingPoints : [] (model initial condition will be used.)

BlockSubstitutions : []

Options : [1x1 linearize.LinearizeOptions]

Input Arguments

s — Interface to Simulink model

slLinearizer interface | slTuner interface

Interface to a Simulink model, specified as either an slLinearizer interface or an

slTuner interface.

Definitions

Analysis Points

Analysis points, used by the slLinearizer and slTuner interfaces, identify locations

within a model that are relevant for linear analysis and control system tuning. You use

analysis points as inputs to the linearization commands, such as getIOTransfer,

getLoopTransfer, getSensitivity, and getCompSensitivity. As inputs to the

linearization commands, analysis points can specify any open-loop or closed-loop transfer

function in a model. You can also use analysis points to specify design requirements when

tuning control systems using commands such as systune.

Location refers to a specific block output port within a model or to a bus element in such

an output port. For convenience, you can use the name of the signal that originates from

this port to refer to an analysis point.

You can add analysis points to an slLinearizer or slTuner interface, s, when you

create the interface. For example:

s = slLinearizer('scdcascade',{'u1','y1'});

Alternatively, you can use the addPoint command.

15 Alphabetical List