Simulink Control Design™ - MathWorks

When you use an analysis point for more than one purpose, the software applies the

purposes in this sequence: output measurement, then loop opening, then input.

Using analysis points, you can extract open-loop and closed-loop responses from a

Simulink model. You can also specify requirements for control system tuning using

analysis points. For more information, see “Mark Signals of Interest for Control System

Analysis and Design” on page 2-53.

Specify Analysis Points

You can mark analysis points either explicitly in the Simulink model, or programmatically

using the addPoint command for an slLinearizer interface.

Mark Analysis Points in Simulink Model

To mark an analysis point explicitly in the model, right-click a signal and, under Linear

Analysis Points, select an analysis point type.

3 Batch Linearization