AWS EDITION 1, 2009

435

Appendix B

© 2009, AWI, AWMAC, WI - Architectural Woodwork Standards - 1st Edition, October 1, 2009

(Appendix B is not part of the AWS for compliance purposes)

CSI Section 08 14 00

Wood Doors

B. [Veneered panels shall be [book] [slip] matched.]

Use this item if Premium Grade is specified.

2. Sticking and panel edge details shall be [per plans] [per manufacturer’s standard details as selected by
   architect].

C. Factory Finishing:

As noted above, Factory Finishing is strongly recommended. In addition to getting a better finish, you

are moving the air quality problems off site, where a proper spray booth will protect the environment

and the health of the finishers. It is still worth while to select a low VOC finishing system, as some

touch up will be required at the job site.

1. All products provided in this Section shall be factory finished using Architectural Woodwork Standards finishing
   system [ _____ ].


2. Finish shall be AWS [Premium -OR- Custom] Grade.

PART 3 - EXAMINATION

3.01 EXAMINATION

A. Verify that frames are set square, plumb, level, and in plane.

1. Report openings that are not within tolerance to the General Contractor for correction before hanging doors.

3.02 INSTALLATION

A. Install all work in conformance with the Architectural Woodwork Standards, latest edition.

1. Installation shall conform to the AWS Grade of the items being installed.

B. Doors shall be secured in place, square, plumb, and level.

C. Hardware shall be installed complete and as recommended by the manufacturer.

3.03 ADJUSTING & TOUCH UP

A. Before completion of the installation, the installer shall adjust all moving and operating parts to function smoothly and

correctly.

B. All nicks, chips, and scratches in the finish shall be filled and retouched. Damaged items which cannot be repaired shall

be replaced.

3.04 CLEANUP

A. Upon completion of installation, the installer shall clean all installed items of pencil and ink marks, and broom clean

the area of operation, depositing debris in containers provided by the general contractor.

END OF SECTION

B