SolidWorks 2010 Bible

Chapter 33: Animating with MotionManager

FIGURE 33.12

The Camera PropertyManager

Notice when you insert the camera, the SolidWorks graphics window splits into two viewports.

The left viewport is your view of the camera, the model, and their surroundings. The right view-

port is the view through the camera.

Using the fixed target method

To attach the camera to the spline and point it at the sketch point, make the following settings:

l Aimed at target. Select this radio button.

l (^) Target by selection. Select this check box and select the 3D sketch point placed inside of
the joint.
l (^) Position by selection. Select this check box and select the spline.
l Set roll by selection. Select this check box and select Top plane.