Chapter 8: Patterning and Mirroring
- Create a linear pattern using the rib, making the pattern reach 2 inches into the
part. - Create a chamfer on the same side of the part as the original rib, as shown in
Figure 8.28. The chamfer is an Angle-Distance using 60° and .5 inches. - Create a round hole, sized and positioned as shown.
FIGURE 8.28
Additional features on the part
- Mirror the hole and the chamfer about the Right plane. The parametrics of the
chamfer will have difficulty patterning, and so you need to use the Geometry Pattern
option. The finished part is shown in Figure 8.29.
FIGURE 8.29
The finished part