INSTALLING THE LINER
When done, clean the oil from the barrel with solvent. You can the liner in the barrel already chambered.
If you want now put the action back in the barrel, remove the extractor from the bolt. Insert a 22 case in
the chamber of the liner. Now coat the inside of the barrel and the outside of the liner with epoxy. Slip the
liner up to 1/8 inch of the bolt, or where the end of the chamber is. Wipe off all the excess epoxy from the
chamber end, close the bolt, and push the liner up flush against the bolt. Once it is flush on the bolt, open
the bolt and wipe off any extra epoxy. If you are careful, the case can be removed also. All that is left to
do is cut the extractor slot, etc.