Digital Audio Recording Basics 547Spectrum shaping is used in CD to prevent data from interfering with the focus and
tracking servos and in RDAT to allow rerecording without erase heads.
A self-clocking code contains a guaranteed minimum number of transitions per unit time, and
these transitions must occur at multiples of some basic time period so that they can be used
to synchronize a phase locked loop. Figure 17.15 shows a phase-locked loop that contains
an oscillator whose frequency is controlled by the phase error between input transitions and
the output of a divider. If transitions on the medium are constrained to occur at multiples of a
basic time period, they will have a constant phase relationship with the oscillator, which can
stay in lock with them even if they are intermittent. As the damping of the loop is a low-pass
fi lter, jitter in the incoming transitions, caused by peak-shift distortion or by speed variations
in the medium, will be rejected and the oscillator will run at the average frequency of the
off-tape signal. The phase-locked loop must be locked before data can be recovered, and
to enable this, every data block is preceded by a constant frequency recording known as a
preamble. The beginning of data is identifi ed by a unique pattern known as a sync pattern.
Irrespective of the channel code used, transitions always occur separated by a range of
time periods which are all multiples of the basic clock period. If such a replay signal is
viewed on an oscilloscope, a characteristic display called an eye pattern is obtained. Figure
17.16 shows an eye pattern, and in particular the regular openings in the trace. A decision
point is in the center of each opening, and the phase-locked loop acts to keep it centered
Phase
compare Damping VCODivide
byNF in
OutputF in
inputN FinPhase
errorControl
voltageFigure 17.15 : A typical phase-locked loop where the VCO is forced to run at a multiple of the
input frequency. If the input ceases, the output will continue at the same frequency until it drifts.