RX8--Transmission (Manual & Auto)

• Inspect for continuity between the selector
  lever (wiring harness-side) and body ground.
  
  M range switch position: terminal B
  and body ground
  
  Up switch position: terminal D and
  body ground
  
  Down switch position: terminal F
  and body ground


• Is there continuity?

No Go to the next step.

Yes

Replace the TCM, then go to the next step.

(See TCM REMOVAL/INSTALLATION .)

9

VERIFY TROUBLESHOOTING OF DTC P0707

COMPLETED

• Make sure to reconnect all disconnected
  connectors.


• Clear the DTC from the TCM memory using
  the WDS or equivalent.


• Drive the vehicle in M range, and change
  gears by shifting the selector lever
  (operating the up and down switches).


• Is the same DTC present?

No No concern is detected. Go to the next step.

Yes

Go to the applicable DTC inspection.

(See DTC TABLE .)

10

VERIFY AFTER REPAIR PROCEDURE

• Perform the "After Repair Procedure".

(See AFTER REPAIR PROCEDURE .)

• Are any DTCs present?

No DTC troubleshooting completed.

(w) RX-8 Transmission (Manual & Auto)