RX8--Transmission (Manual & Auto)

• Turn the ignition switch to the LOCK
  position.


• Inspect the TFT sensor.

(See TRANSMISSION FLUID

TEMPERATURE (TFT) SENSOR

INSPECTION .)

• Is the TFT sensor normal?

No

Replace the TFT sensor, then go to the next step.

(See TRANSMISSION FLUID TEMPERATURE

(TFT) SENSOR REMOVAL/INSTALLATION .)

Yes

Replace the TCM, then go to the next step.

(See TCM REMOVAL/INSTALLATION .)

7

VERIFY TROUBLESHOOTING OF DTC

P0711 COMPLETED

• Make sure to reconnect all
  disconnected connectors.


• Clear the DTC from the TCM memory
  using the WDS or equivalent.


• Decrease ATF temperature to 20 °°°° C
  {68 °°°° F} or less.


• Start the engine.


• Drive the vehicle for 6.5 min or more.


• Is the same DTC present?

No Go to the next step.

Yes

Go to the applicable DTC inspection.

(See DTC TABLE .)

8

VERIFY AFTER REPAIR PROCEDURE

• Perform the "After Repair Procedure".

(See AFTER REPAIR PROCEDURE

.)

• Are any DTCs present?

No DTC troubleshooting completed.

(w) RX-8 Transmission (Manual & Auto)