Mechanical APDL Structural Analysis Guide

cessor). See the Output Data sections of the element descriptions for any of the interface elements (for
example INTER192) for a description of the available output components.

Note that in POST1, only one substep can be read in at a time, and that the results from that substep
should have been written to Jobname.RST. ( The load step option command OUTRES controls which
substep results are stored on Jobname.RST.) A typical POST1 postprocessing sequence is described
below.

10.7.1. Points to Remember

• To review results in POST1, the database must contain the same model for which the solution was
  calculated.


• The results file (Jobname.RST) must be available.

10.7.2. Reviewing Results in POST1.

1. Verify from your output file (Jobname.OUT) whether or not the analysis converged at all load steps.
   
   
   • If not, you probably won't want to postprocess the results, other than to determine why convergence
     failed.
   
   
   • If your solution converged, then continue postprocessing.
   
   
   
   


2. Enter POST1. If your model is not currently in the database, issue RESUME.
   Command(s):/POST1
   GUI: Main Menu> General Postproc


3. Read in results for the desired load step and substep, which can be identified by load step and substep
   numbers or by time.
   Command(s):SET
   GUI: Main Menu> General Postproc> Read Results> load step


4. Display the results using any of the following options. Note that gasket results, such as pressure and
   closure, are always displayed and listed in the local coordinate system.

Option: Display Deformed Shape

Command(s):PLDISP

GUI: Main Menu> General Postproc> Plot Results> Deformed Shape

Option: Contour Displays

Command(s):PLNSOL or PLESOL

GUI: Main Menu> General Postproc> Plot Results> Contour Plot> Nodal Solu or

Element Solu

Use these options to display contours of stresses, strains, or any other applicable item. When display-

ing the gasket pressure distribution, if other structural mating components are not included, ANSYS

will plot the geometry of those components in gray. To have a better visualization of a gasket

pressure plot, it is better for you to select gasket elements only.

Option: Tabular Listings
Command(s):PRNSOL (nodal results) PRESOL (element-by-element results) PRRSOL (reaction data)
PRITER (substep summary data), etc.
GUI: Main Menu> General Postproc> List Results> Nodal Solution

Release 15.0 - © SAS IP, Inc. All rights reserved. - Contains proprietary and confidential information

Gasket Joints Simulation