BLBS102-c20 BLBS102-Simpson March 21, 2012 13:35 Trim: 276mm X 219mm Printer Name: Yet to Come
370 Part 3: Meat, Poultry and Seafoods
(A)
(B)
(C)
Raw material
Clean and size reduction
Remove
noncollagenous proteins
Remove fats and pigments
- Alkaline treatment using 0.1 N NaOH at a ratio of
1:10 (w/v). - Wash thoroughly with distilled water until neutral pH
is obtained. - Stir in 10% butyl alcohol at a ratio of 1:10 (w/v).
- Wash with distilled water.
Soak in 0.5 M acetic acid
Centrifuge/filter
Supernatant(A)
Residue
Soak in 0.5 M acetic acid
in presence of pepsin
Supernatant(P) Centrifuge Residue
Discard
Supernatant (A)and (P)
Add NaCl to final conc. 2.6 M
in 0.05 M Tri-HCl, pH 7.5
Supernatant Centrifuge
Discard
Pellet
Dissolve in
0.5 M acetic acid
Dialyze against
0.1 M acetic acid
Dialyze against
distilled water
Freeze-dry
ASC ASCor PSCPSC
Figure 20.3.Flow chart for the preparation of acid soluble collagen (ASC) and pepsin soluble collagen (PSC). All procedures are performed
at 4◦C. (A) Preparation of raw material. (B) Extraction. (C) Recovery.
(Duan et al. 2009, Nalinanon et al. 2010, Kittiphattanabawon
et al. 2010a). Collagen from total tissue can be isolated by direct
extraction with organic acids (acetic, chloracetic, citric, lactic)
or inorganic acid (hydrochloric). The yield of extracted collagen
depends on the animal species used and the age and parameters
of extraction (Skierka and Sadowska 2007). Collagen extraction
from different species has been performed using acetic acid.
Collagen extraction is generally achieved by 0.5 M acetic acid
treatment at 4◦C for 24–48 hours. Compared to simply prolong-
ing the extraction time, the use of several consecutive extraction
may get better ASC yield (Sadowska et al. 2003, Regenstein
and Zhou 2007, Skierka and Sadowska 2007). Nalinanon et al.
(2008) found that ASC yield from the skin of threadfin bream
was increased from 12.32% to 34.90% (based on hydroxypro-
line content), when extended the extraction time from 6 to 48
hours. The similar result was observed in collagen extraction
from bigeye snapper skin, in which the yield increased from
7.3% to 9.3% (based on hydroxyproline content) with increas-
ing extraction time from 24 to 48 hours (Nalinanon et al. 2007).
Increasing the concentration of acetic acid used from 0.1 to
0.5 M resulted in the increased yield of collagen extracted from
minced cod skin, from 52% to 59% (dry weight). Re-extraction
of residual matter with 0.5 M acetic acid can be performed to
increase the yield of ASC, particularly in carp bone (Duan et al.
2009), bigeye snapper skin and bone (Kittiphattanabawon et al.
2005).
Skierka and Sadowska (2007) studied the influence of differ-
ent acids on the extractability of collagen from the skin of Baltic
cod (Gadus morhua). The maximal yield of collagen extracted
with 0.5 M citric acid and acetic or lactic acids was 60% and 90%