Lesson 5 – Modeling Miscellaneous Rubber Parts
Section II – Modeling Simple Parts 5.4 Modeling the Truck Bumper
Select the Draft On/Off option and type 5 degrees draft.
Click the check mark to accept.
Use Section View in the View Heads-Up toolbar to verify that the diameter is smaller at
the end of the extrusion.
Step 31: Create a dome cavity on the surface created by the Extruded Cut.
Click the surface.
Click the Dome command.
Type 0.21 inch in the distance input box.
Click the Reverse Direction arrows to toggle the dome and to create a cavity instead of
a solid dome. See Figure 5.5.
Click the check mark to accept.
Figure 5. 4 – InsertCutExtrude