Scale aviation modeller international
OFTEN IMITATED, NEVER BETTERED DELIGHTFUL DOLPHIN Wingnut Wings 1/32 Sopwith Dolphin F. A BLUE IMPULSE Hasegawa 1/72 T-4 Blue Im ...
CHANGE THE WAY YOU PAINT WWW.MISSIONMODELSUS.COM MISSION PREMIUM HOBBY PAINTS, PRIMERS & ADDITIVES MODELS Please visit our w ...
Fw 190A- 1/48 Eduard http://www.eduard.com NOW IN 1/48 SCALE! Cat. No. 644002 Brassin pre-paintend dashboard Seatbelts STEEL Eas ...
22 A Blue Impulse Hasegawa 1/72 T-4 Blue Impulse 2017 Markings by Jonathan Davies 30 Full-On Phantom Jay Blakemore Strays from H ...
were powered by Bristol Pegasus 9-cylinder radial engines and carried two twin-gun Frazer-Nash FN-5 turrets for self The early M ...
Airfix’s New 1/72 Vickers Wellington Mk.1a by Huw Morgan A casual examination of the activities of the RAF Bomber Command during ...
The early Mk I/Ia versions were powered by Bristol Pegasus 9-cylinder radial engines and carried two twin-gun Frazer- Nash FN-5 ...
BUILD Since the Editor had asked for an out-of-the-box build, I decided to include all the internals offered by Airfix, and set ...
closure panel, which is moulded as part of the upper wing. The instructions suggest fitting the main undercarriage legs at this ...
rather tricky compound curves of the turret glazing, I couldn’t resist. Typical of Eduard, the masks are superb, albeit in a cou ...
them during further masking. To this end I applied the two upper surface roundels, preparing the surface first with a thin brush ...
FINALS There’s very little to do at the end of the build; I had left the undercarriage off, so that needed fixing and the wheels ...
006-13-FEAT-Wellington-1018.indd 13 14/09/2018 15: ...
W hen it was introduced to RAF service in 1969 the Harrier was a revolutionary aircraft with a unique vertical take-off and land ...
who are not aviation enthusiasts. It is therefore hardly surprising that there have been many kits in all the major scales (and ...
MAKING A START After all that preamble – thank you for your indulgence in reading it – let’s get on with it. The first job was t ...
good representation of real dials, with perhaps just a drop of your favourite clear varnish to replicate glass. I decided to lea ...
install the stubs of the latter first, then add the etch when dry. Again, this is an improvement, even though the kit part will ...
well, but don’t have a “flat” moulded on them. A short filing job fixed that. The hubs and tyres for the nose and main undercarr ...
will be difficult, if not impossible, to apply with the tailplanes fitted. Next was the tail fin, and this didn’t fit so well, b ...
«
1
2
3
4
5
»
Free download pdf