Dave Gerr - Boat Mechanical Systems Handbook-How to Design, Install, and Recognize Proper Systems in Boats
Chapter 10: Rudder Geometry, Shape, and Size well faired. Both can cause vibration and tur- bulence, and both can lead to loss o ...
Wood Outboard Rudder Thickness Some traditional sailboats have what is essentially a wooden flat-plate rudder hung on gudgeons a ...
Chapter 10: Rudder Geometry, Shape, and Size speed of 8.72 knots, the rudder laminate shell thickness should be as follows: or T ...
As a practical matter, the difference in steer- ing response between C and D won’t be great. Rudder D will be the least expensiv ...
Chapter 10: Rudder Geometry, Shape, and Size Spade rudders should have their leading edges angled slightly aft to shed debris—li ...
opposite direction, then the rudders are installed inboard of the shaft. As with spade rudders, the leading edge of the rudder b ...
Chapter 10: Rudder Geometry, Shape, and Size Figure 10-15. Effective rudder angles at different points during a turn and at diff ...
CHAPTER 11 Once you’ve determined the size, shape, and location of the rudder, you need to ensure that the rudder stock is stron ...
Pf =Propeller factor 1 .0 for boats where the propeller is more than 2.5 times propeller diameter forward of the rudder (usually ...
PART FOUR: RUDDERS AND STEERING SYSTEMS geometric center point. This line is the effec- tive mean chord. Measure 35 percent of t ...
Chapter 11: Rudder-Stock Size, Construction, and Bearing Specification TM =8,512 lb.× 3. 64 in. =30,984 in.-lb. BM =8,512 lb.× 2 ...
PART FOUR: RUDDERS AND STEERING SYSTEMS Note that Nm has to be multiplied by 1,000 to get Nmm so that all the units are the same ...
Chapter 11: Rudder-Stock Size, Construction, and Bearing Specification Example:So or 93 .05 mm dia. = 9 .305 cm dia. 10. OPTIONA ...
PART FOUR: RUDDERS AND STEERING SYSTEMS custom fabricating and machining solid aluminum rudder stocks of 6082. These can be mach ...
Chapter 11: Rudder-Stock Size, Construction, and Bearing Specification NOTE: Nm has to be multiplied by 1,000 to get Nmm. Silico ...
PART FOUR: RUDDERS AND STEERING SYSTEMS Find bearings that have enough area to fall below the allowable stress (see Table 11-3). ...
Chapter 11: Rudder-Stock Size, Construction, and Bearing Specification Figure 11-2. Typical fabricated rudder port ...
PART FOUR: RUDDERS AND STEERING SYSTEMS Rudder-Bearing Clearance Because the rudder stock must be free to turn in the bearings, ...
Chapter 11: Rudder-Stock Size, Construction, and Bearing Specification So Bearing OD = 5. 000 in., + 0. 000 in., –0. 002 in. Rud ...
PART FOUR: RUDDERS AND STEERING SYSTEMS On metal hulls, the entire rudder port is usually built into the hull, and the rudder-po ...
«
6
7
8
9
10
11
12
13
14
15
»
Free download pdf