Model Engineers’ Workshop – July 2019

July 2019 21 › Denford Synchro the cover which would have prevented the lathe being started when the cover was open, but this ha ...

22 http://www.model-engineer.co.uk Model Engineers’ Workshop didn’t quite agree with the plate on top of the headstock which sho ...

July 2019 23 › Denford Synchro drawings for the quadrant, the gears and all the fittings. I set to making a pattern for the quad ...

24 http://www.model-engineer.co.uk Model Engineers’ Workshop Denford lathes don’t seem as well known these days, and certainly d ...

...

26 http://www.model-engineer.co.uk Model Engineers’ Workshop Rust Sub-Plates Knurling Southbend Scribe a line YOUR CHANCE TO TAL ...

July 2019 27 Readers’ Letters Grinding Rest Healthy Cutting Oil? Bombe Happy Reader Dear Neil, I recollect seeing an article in ...

28 http://www.model-engineer.co.uk Model Engineers’ Workshop Wire On the NEWS Hobby Engineering from the World of Aft er long an ...

July 2019 29 › Bearing Removal Out, Out Damned Bearing I n the recent past, I have had to remove three bearings from blind holes ...

30 http://www.model-engineer.co.uk Model Engineers’ Workshop were clear. I had chosen a scrap piece of aluminium which had been ...

July 2019 31 Bearing Removal result of trying to ingest part of a shield or cage. This half outer was fi rmly embedded into a bl ...

ǫro‰;u=†Ѵ-m7-@ou7-0Ѵ;ƒ 7;vb]mr-1h-]; ǫ-v‹|oѴ;-umķ;-v‹|o†v;-m7ru;1bv;lo7;ѴѴbm] o=‹o†uruof;1|v ǫŠrou| ...

July 2019 33 › Hydraulic Press A Hydraulic Press James Perry describes how to make a workshop press around a hydraulic jack. Par ...

34 http://www.model-engineer.co.uk Model Engineers’ Workshop the 2mm wide flat on the face of the blade imprinted itself on the ...

July 2019 35 › Hydraulic Press When doing any bending with the press it was important not to over-bend. Experience showed that l ...

36 http://www.model-engineer.co.uk Model Engineers’ Workshop to show the pitfalls and point the way forward. My intention was to ...

July 2019 37 › Hydraulic Press 33 34 35 ...

38 http://www.model-engineer.co.uk Model Engineers’ Workshop Aft er each pass the tool tended to jam in the slot and it was nece ...

...

...