Old Cars Weekly News \& Marketplace - Auto Restoration Guide: Advice and How-to Projects for Your Collector Car

O Cars Guide to Auto Restoration, Summer 2010), it is now ready to have a cut-and-sewn cover fitted ...

Photo E Photo F Attaching the cover to the frame With the cover resting on the spring, turn the unit ove ...

corners. Now apply this same procedure to the back border, except apply corner staples about 6 inch ...

Tweaking the cover Start the tweaking process in the front. Measure 6 inches down from the bottom of the welting ...

a straight welting across the front of the cushion, 6 inches up from the bottom of the wood frame. Begi ...

Photo L Once satisfied with the front, focus on the side panels again. Pull up and back and stapl ...

Photo N Photo O Photo P ...

Final attachment of the back panel You are now ready to continue to secure the back panel to the wood fram ...

Final back corner detail To finish off the corner, bring the two sides panels of the cor ...

W The Whiter Side: SWAPPING OLD, BLACK GAUGES FOR A BRIGHTER LOOK Here we are at the start. Even after c ...

Now, since a lot of the big work is done, it’s that time where the bits and morsels of the arduous tas ...

http://www.eastwood.com 800-343-9353 I went to www.whitegauges.net and ordered a set of freshly cut white gauge fac ...

The ’64 bezel is held to the dash frame by four large screws around the perimeter. My dash is already o ...

Before you can remove the bezel, twist off the metal ignition bezel. This would also be a good time t ...

I took a damp paper towel and lightly cleaned the surfaces of any dirt or contaminates that might ...

The kit comes with easy-to-read, well diagrammed instructions to make this operation a snap. What I ...

To get the face on, thread the needle through the center hole. DO NOT REMOVE THE SPEEDO NEEDLE! After it is throu ...

A small squeegee is included to push out any air or water bubbles that might form while placing the ...

Use the squeegee to push out any air bubbles. A pin can be used to lightly pop any bubble you can’t work o ...

I picked up a few artist’s brushes from the dollar store and then combed my paint shelf for a color tha ...