- Insert wires to connect the ICs, terminal block for the microphone car-
tridge, terminal blocks for the potentiometer (R2), terminal block for
the headphone jack, and discrete components, as shown in Figure 6-8. - Insert the 0.047 microfarad capacitor (C5), two 10 microfarad capaci-
tors (C2 and C3), one 100 microfarad capacitor (C4), one 0.1 micro-
farad capacitor (C1), one 5.6 kohm resistor (R1), and one 10 ohm
resistor (R3) on the breadboard, as shown in Figure 6-9.
When inserting electrolytic capacitors, be sure to check the schematic
for where to insert the longer + lead.
We discuss in Chapter 4 how you can determine how short to clip the
leads of many of these components to make them fit neatly on the bread-
board. And you knew we were going to say it: Make sure you wear your
safety glasses when clipping leads!
Open region
to headphone jack TB
Pin 5 of IC 1
to open region
Microphone TB
to open region
Open region
to R2 TB
Pin 8 of IC 1
to open region
R2 TB
to Pin 3 of IC 1
Figure 6-8:
Hook up the
ICs, terminal
blocks, and
discrete
components.
Chapter 6: Focusing Sound with a Parabolic Microphone 125