TOYOTA PREVIA 91-97 REPAIR MANUAL

SUSPENSION AND STEERING 8-13 a. Remove the 2 nuts and bolts on the lower side of the shock absorber. b. Remove the steering knuc ...

8-14 SUSPENSION AND STERING Fig. 36 Using a flatbladed tool, pry off the grease cap models Fig. 37 With chisel and hammer, relea ...

SUSPENSION AND STEERING 8-15 4WD Fig. 42... extract the inner oil seal with a puller Fig.^44 Then press the old bearing out of t ...

8-16 SUSPENSION AND STEERING LL. JOINT CASTER IS POSITIVE WHEN THE LOAD (LOWER BALL JOINT) IS AHEAD OR PL THE SPINDLE. LLING Fig ...

REAR SUSPENSION COMPONENTS 1. Coil spring 2. Shock absorber 3. Load Sensing ProportioningValve (LSPV) spring 4. Upper control ar ...

8-18 SUSPENSION AND STEERING Coil Springs REMOVAL & INSTALLATION Raise and support the rear of the vehicle. Remove the rear ...

SUSPENSION AND STEERING 8-19 Fig. 52... a washer will come out with the bolt Fig. 54 When fluid is seeping out of the shock abso ...

8-20 SUSPENSION AND STEERING Fig. 55 Lower control arm (1), upper control arm (2) and spring (3) Install the coil spring on the ...

SUSPENSION AND STEERING 8-21 On models with ABS, remove the ABS warning harness bracket. Disconnect the Load Sensing Proportion ...

8-22 SUSPENSION AND EERING Loosen the trim pad retaining screws from the back side df the steer- ing wheel. Remove the pad by l ...

SUSPENSION AND STEERING 8-23 Fig. 63 Push down on the tab to release the clip Fig. 66 Remove the nut on the end of the steering ...

8-24 SUSPENSION AND ST:ERING Fig. 69 ... then install a puller Fig. 70 Lift the steering wheel off the shaft Fig. 71 Always read ...

SUSPENSION AND STEERING 8-25 Turn Signal (Combination) Switch REMOVAL & INSTALLATION See Figure 72 Without Airbag System T ...

8-26 SUSPENSION AND STiERING Red Mark Fig. 74 Always align the red mark on the spiral cable Remove the instrument lower finish ...

SUSPENSION AND STEERING 8-27 Fig. 75 Remove the cotter pin and discard it Fig. 78 Place a puller between the knuckle and end ... ...

8-28 SUSPENSION AND STEERING Fig. 81 Now pull the end off the steering rack Fig. 82 Each tie rod is marked with an L or R for le ...

SUSPENSION AND STEERING 8-29 Pressure and Return Tube it (ISO, 331~ No. 2 Equipment Drive Housing Insulator LH Engine Under Cove ...

8-30 SUSPENSION AND STEERING Engine Cooling Fan with Coupling 48(490. 35) 36(370.27) Stay N-m (kgf-cm, fMbfjj : Specified torque ...

SUSPENSION AND STEERING 8-31 TORQUE SPECIFICATIONS Components Front Suspension: Axle hub bearing lock nut (2WD) Tie rod end-to-s ...

8-32 SUSPENSION AND STEERING Troubleshootir nrfOOIitH i,i, •. Chirp noise in steering pump • Loose Belt squeal (particularly not ...