SUSPENSION AND STEERING 8-21
- On models with ABS, remove the ABS warning harness
bracket. - Disconnect the Load Sensing Proportioning Valve spring from the
lower control arm. - Disconnect the shock absorber from the lower control arm.
- Remove the nut and bolt retaining the lateral control rod. Extract the
lateral control rod with the bushings.
To install: - Install the lateral control rod with bushings. Temporarily install the
bolt and two nuts. - Connect the shock absorber to the lower control arm and tighten the
new until the bolt protrudes 0.059 inch (1.54mm) or more. - Connect the LSPV spring to the lower control arm and tighten to 9
ft. Ibs. (13 Nm). - On models with ABS, install the ABS wiring harness bracket.
- If removed, connect the brake hose to the body with the clip. Attach
the brake tube. - Lower the vehicle and stabilize the suspension. Bounce the vehicle
up and down several times to stabilize the suspension. - Jack up the vehicle and support the rear axle housing with stands.
- Tighten the nuts of the lateral control rod on the body side to 156 ft.
Ibs. (211 Nm) and the axle housing side to 43 ft. Ibs. (59 Nm). - If the lines were cracked, bleed the brake system.
- Lower the vehicle.
STEERING
Steering Wheel
REMOVAL & INSTALLATION
WARNING
Do not attempt to remove or install the steering wheel by ham-
mering on it. Damage to the energy-absorbing steering column
could result.
1991 Models
» See Figure 57
i-The 1991 models are the only Previa vans that are not equipped
with an air bag.
- Disconnect the negative battery cable. Position the front wheels
straight ahead. - Unfasten the horn and turn signal multi-connector(s) at the base of
the steering column shroud.
Wheel Pad
350 (25. 34)
Steering Wheel -
Column Cover -
Pin
Shift Control Cable
Clip-
- Combination Switch
Shift Indicator Cable
260(19.25)
Steering Column ~ 260119. 25)
185 (13. 18)
360 (26. 35) j Lower Right Finish Panel
j kg-cm (fl-lb. N-m) 1 : Specified torque
Fig. 57 View of the common steering wheel and column assemblies