TOYOTA PREVIA 91-97 REPAIR MANUAL

BODY AND TRIM 10-13

Fig. 35 When removing the glass, slide it rearward to extract

17. Install the panel with two nuts and secure.


18. Slide the glass forward to insert into the slide roof rail, install the
    glass to the drive cable. Install the four nuts.


19. Slide the sliding roof rearward to the rear end. Remove the screw
    and cam plate cover. Loosen the large strew at the back side of the drive
    shaft, then turn the drive shaft by hand to align the housing and gear point
    mark as shown in the illustration. Install the cam plate cover with the screw,
    attach the wiring. Install the motor and secure with the nuts and bolt.


20. Adjust the roof.


21. Install the sliding roof garnish and secure.


22. Install the front roof side garnish and secure with the five nuts and
    screw.


23. Tap the rear roof side garnish to install and secure with the screw.


24. Doubler check that all garnishes and components are secure, there
    is nothing worse than installing all the components and having a rattle.


25. Install the headliner.


26. Connect the negative battery cable.

INTERIOR

Instrument Panel and Pad

REMOVAL & INSTALLATION

t See Figures 38 thru 49

1. Disconnect the negative battery cable. Wait at least 90 seconds on
   models equipped with an airbag.


2. Remove the assist grips on either door.


3. Carefully remove the garnishes on the door pillars.


4. Pull the rear edge of the side defroster nozzle upward and remove it.


5. Remove the steering wheel.


6. Unscrew and separate the steering column covers.


7. If necessary, remove the door scuff panels.


8. Remove the two screws and extract the side panel.


9. If necessary, remove the hood release lever. Unscrew the lever and
   pull if forward to remove.


10. On the cluster finish lower panel remove the two small covers and
    remove the 5 screws retaining the panel.


11. Five bolts retain the knee panel, loosen and remove them.


12. Push up the release lock at the center on the lower side of the clus-
    ter finish center upper panel.


13. On the console box, press on the sides of the box while pulling the
    box outward, then remove the box.


14. On the ash tray and cup holder, remove the four screws and extract
    the ash tray retainer and cup holder. Disconnect the wiring.

Fig. 36 Common clip removal procedures Fig.^37 Common clip removal procedures (continued)