10-12 BODY AND TRIM
BUMPER- ^
RETAINER
Fig. 31 View of the fenders, liners and other front end compo-
nents
Power Sunroof
REMOVAL & INSTALLATION
I See Figures 32, 33, 34 and 35
- Open the sliding moon roof.
- Disconnect the negative battery cable. Wait at least 90 sect
before proceeding on models equipped with an air bag. - Remove the roof headliner.
- Unscrew and remove the rear roof side garnish. The trim c
carefully pulled off. Watch for broken clips and replace as needed. - Remove the front roof side garnish. There is one screw anc
nuts. - Remove the drive motor retained by two nuts and a bolt. D
the wiring attached to the motor. - Detach the sliding moon roof garnish held in place with o
screw. - Remove the sliding moon roof glass from the cable held in
nuts.
a. Slide the glass rearward to remove it. - Remove the wind deflector panel, only two nuts retain the p
- Unscrew and separate the slide roof rail. Remove the four n
the side roof front rail. Remove the three nuts and slide the rear ra - Remove the roof guide nut and slide the guide off.
- Remove the eight bolts for the drive cable and extract the c
- Pull the weatherstip off the roof.
To install: - Attach the weatherstrip to the opening in the roof.
- Attach and secure the drive cable with the eight bolts.
- Install the slide roof rear guide. Position and secure the fro
with the nut.
ds
be
connect
iy four
nel.
tsand
2 Clips
3 Clips
Fig. 32 When removing the rear side garnish on the sunroof, be
careful pulling on the clips
Fig. 33 The front roof side garnish is attached with one screw
and five nuts
guide
Fig. 34 Remove the sunroof motor, then disconnect the wiring