Illustrated Guide to Home Chemistry Experiments

(Amelia) #1
Chapter 7 Laboratory: Solubility and Solutions 143

POCEDURER


CUTIOA nS:
Copper sulfate is moderately toxic by ingestion or
inhalation and is irritating to eyes and skin. Wear splash
goggles, gloves, and protective clothing at all times.

z


PRTI: A mA kE UpREfERENCE SoLUTIoNS




  1. If you have not already done so, put on your splash
    goggles, gloves, and protective clothing.




  2. Label six test tubes #1 through #6.




  3. Use the 5.00 mL pipette to transfer 10.00 mL of distilled
    water into test tube #1, and 5.00 mL of distilled water
    into each of the other five test tubes.




  4. Place a weighing paper on the balance and tare the
    balance to read 0.00 g.




  5. Weigh out about 2.40 g of copper sulfate, record the
    mass to 0.01 g on line A of Table 7-2 under “Test tube #1,”
    and transfer the copper sulfate to test tube #1.




  6. Swirl test tube #1 until all of the copper sulfate
    has dissolved.




  7. Use the 5.00 mL pipette to transfer 5.00 mL of the
    copper sulfate solution from test tube #1 to test tube #2.




  8. Swirl test tube #2 until the distilled water and copper
    sulfate solution is thoroughly mixed.




  9. Repeat steps 7 and 8 for test tubes #3, #4, and #5.
    When you finish, each of the five test tubes should
    contain a solution of copper sulfate at half the
    concentration of the preceding tube. Test tube #1 should
    have an intense blue color, with each succeeding test
    tube a paler blue.
    Calculate the mass of copper sulfate in each of the tubes
    #2 through #5 and the mass-to-volume percentage of
    tubes #1 through #5, and enter those values in lines A and
    B of Table 7-2.




This laboratory has two parts. In Part I, we’ll make up solutions
that contain known concentrations of copper sulfate. In Part
II, we’ll make up a solution with an unknown concentration of
copper sulfate and estimate the concentration of that unknown
solution using visual colorimetry.


dISpoSAL: Copper sulfate solutions may be neutralized
with sodium carbonate and the precipitate can then be
disposed of with household waste. Alternatively, small
amounts of copper sulfate solution may be flushed down
the drain. (Copper sulfate is, after all, sold as root killer,
for which purpose it is—you guessed it—flushed down
the drain.)

TABLE 7-2:


Determine concentration of a solution by visual colorimetry (standard solutions): observed and calculated data


Item Test tube #1Test tube #2Test tube #3Test tube #4Test tube #5

A. mass of
copper sulfate___._________ g___._________ g___._________ g___._________ g___._________ g

B. mass-
to-volume
percentage____.________%____.________%____.________%____.________%____.________%

10.

Free download pdf